DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Super Moderator
Joined
·
15,484 Posts
You need to look for a loose white wire either at the first non-working receptacle or the last working receptacle. If the wires are stabbed in the back it would be better to make a loop and place it clockwise under the screw and tighten the screw.
 

·
Too Short? Cut it Again!
Joined
·
9,634 Posts
I know you tested the breaker but did you check to make sure the neutral to the box and for that circuit was tight?
 
1 - 3 of 3 Posts
Top