No hot air with filter in place

387 Views 7 Replies 5 Participants Last post by Spamoni, Feb 21, 2020

Spamoni

Discussion Starter · Feb 5, 2020

Hi, my forced air gas heater recently developed a problem. When I have a filter in, the heat will unpredictably stop heating and blow cold air instead. I read about this being caused by a dirty filter and when I took the filter out and reset it worked fine. However when I put a new filter in I have the same problem. I tried the least resistant filter, MERV 4 or 6, and still had the problem. With the filter now out it hasn't happened in over a month. I'd like opinions on whats wrong before I call a repair guy.

Save

1 - 1 of 8 Posts

ktownskier

· #3 · Feb 6, 2020

Make sure that you are not using too high of an efficient filter. It may make it too hard to pull/push the air through.

And of course, you have changed the filter recentlty, correct?

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month