DIY Home Improvement Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello all - this is my first time posting here. For some background our house is about 5 years old and we have Marvin double hung windows and doors. Aluminum clad outside - pre-primed wood on the inside. Where we live is by the beach so the weather can be damaging. Here's my problem. All of the windows and doors are being replaced by Marvin because apparently there was an issue when the windows were built in the factory. I believe it has to do with the glass and the outside finish.

Problem is that when the windows/doors were delivered everything was placed in the garage for storage. During the week while I was away we had a huge rain storm and as a result the garage flooded with about ankle deep water. All the windows and doors were in there on their sides in the delivery material. I have measure it to be about 3 or 4inches of water. Just to clarify I was shipped only the doors and the windows themselves - the frames were not going to be changed. My question is will this water have any impact on the windows? Should I not use these windows? I now have most of them inside my house where it is temperature controlled. All the windows do feel dry. I am concerned and not sure what to do.

They are supposed to be painted and installed this week.

Also 2nd question should these be painted once installed or paint before install? The problem I had when we first bought this house was a large number of the windows stuck and were impossible to open. The builder of the house wants to install them and then paint them and claims if we leave the AC on there will be no problem.

Any advice?

Thank you very much.
 

·
Home Performance
Joined
·
1,542 Posts
I'd put up a stink and try to get them replaced. Standing water does no good for a wood window..... That being said, Marvin has to warranty them either way, so if they don't have any problems, you might be stuck putting them in.
 
1 - 2 of 2 Posts
Top