DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I installed a new sink and faucet and this thing will be the death of me.
After seating the drain for the 4th time it finally stopped leaking.

Now I was adjusting the mounts for the hot and cold handles. When first installed water ran fine and rather forcefully. Now all of the sudden there is very low pressure and it remains the same flow if i run full hot, full cold, or both hot and cold at full.

PLEASE help me!!!!!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top