DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,646 Posts
did you take the aerator out and flush the faucet out? most of the time when you shut off the valves under the sink deposits inside them gets broken loose, then when you turn them back on it goes into the faucet and usually lodges in the aerator at the end of the spout. unscrew it and make sure get the rubber washer out also, sometimes it sticks in the end of the spout. open the hot andn cold one at a time and see if the pressure is good without the aerator. worst case is the crud lodged in the faucet stem and you would need to turn off the supply shutoffs and remove the stem and clean them but ususlly its in the aerator.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top