DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Learning by Doing
Joined
·
3,156 Posts
Discussion Starter · #1 ·
I dug out an old clock made of one single decorative tile and am replacing the movement. When I pulled the movement out the cardboard backing on the tile - that held the 'hanger' and 'easel stand' pulled off and fell apart. Apparently, the glue was only good for 15 years. :laughing:

The back of the tile has a 'rough' back (imprint from canvas it was 'laid' on). What should I use to glue a new hanger back onto the tile?

Thanks for any ideas....:thumbup:

On the plus side, I can still buy a movement made in the USA. :)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top