[imautoparts]

My original flat-washer (or flat bar?) brackets rusted off my delta washerless kitchen faucet. I'd like to get a couple of these bell shaped brackets instead:

I see it is labeled "bracket". What kind of bracket, and where can I get them? The "bells" would be big enough to go over the top of the old, rusted nut and I could spin new nuts on to tighten the faucet back into the sink.

The original brackets have simply crumbled away. Am I correct in not wanting to disturb the original nuts? I'd hate to damage the mount rods by trying to loosen rusted on nuts if I don't have to.

 

[TheEplumber]

If you're going down the "replace parts" road you're best off to call the factory rep.
Me- I'd get a new faucet or fabricate the parts you need

 

[joecaption]

If it's that old it's time to go.

 

[ben's plumbing]

My original flat-washer (or flat bar?) brackets rusted off my delta washerless kitchen faucet. I'd like to get a couple of these bell shaped brackets instead:

I see it is labeled "bracket". What kind of bracket, and where can I get them? The "bells" would be big enough to go over the top of the old, rusted nut and I could spin new nuts on to tighten the faucet back into the sink.

The original brackets have simply crumbled away. Am I correct in not wanting to disturb the original nuts? I'd hate to damage the mount rods by trying to loosen rusted on nuts if I don't have to.

the bracket rusted off because base of faucet is leaking ..must be a small leak...but if you dont repair the leak it will only get bigger....i say replace faucet also..ben sr