DIY Home Improvement Forum banner

My busbar insulator? is melted how dangerous is this

6971 Views 4 Replies 4 Participants Last post by  AllanJ
The lights and plugs had tripped upstairs, last night. When I went to check out the panel I heard sizzling. I removed the cover panel. The busbar on the right (125 amp Panel) at the very top has melted the plastic holder. It scared me so I turned the main off. I called my electric company this morning, SMUD. Told them that I wanted to have the power disconnected and wanted to know the procedure. I wanted to upgrade from 125 amp panel to a 200. They told me it would take 3 to 5 days to have that done and I had to talk to their designer what the....So I am without power and I am cold and so is my kid! No power is no fun. SMUD said to get the bus bar repaired until I could talk with the designer. I went and pulled a permit today anyway. My question is, since SMUD isn't too worried am I just over reacting? Can I REALLY continue to use power?


See less See more
1 - 1 of 5 Posts
You need a new panel and possibly a service upgrade.
They always say that. You're in SAC right? You're most likely going to be pushed around a bit. A local contractor with some clout could probably get you done a lot faster. Is it overhead or underground?
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.