DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hey guys kind of new to the diy thing, but have been enjoying remodeling an old house. Haven't made but one previous post, and it was very helpful.

O.k. so here is my situation. I put an addition on the back of the home for a bathroom, and have my watter supply ran to where my bathtub/shower will be. I have plenty of room for an access panel, and have the shut off valves already installed. I am getting ready to set the tub up, and am not sure what I need to do it? It is one of those fiberglass one piece bathtub/shower combo's, and I am not sure if I need a mortar bed or what I need to put under it for support. My floor is dead level, and I hear that is very good. But, after that I have no idea of what I need to do. If anyone has any links or advise, it would be greatly appreciated.

Thanks in advance....
 
1 - 3 of 3 Posts
Top