DIY Home Improvement Forum banner

Mini-Split flare tool reccomendations

946 Views 3 Replies 4 Participants Last post by  supers05

I'm thinking I want to cut my pre-flared line-set and re-flare the ends to avoid excess line-set draping around my attic.

Amazon has a Flexzion flare tool for 26 dollars shipped:

Given this is likely a one-time-job use, would this fit the bill? Any one have any concerns of going this route?

I have 3/8" and 1/4" tubing to flare.
1 - 1 of 4 Posts
Looks good. I would do a few test flares to make sure you get them right.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.