DIY Home Improvement Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I'm looking to wall mount a device that runs of 12 VDC, and would like to provide power to it in a 'clean' manner. I would like to mount power supply like a laptop brick inside a triple gang box, covered by a blank...however I'm not sure this is allowable by code.

Any thoughts?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.