DIY Home Improvement Forum banner
1 - 13 of 13 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Again I was over helping a friend with some light fixtures. Their light above the sink says it is rated at 120v 75w. The bulbs they are using are a 65w, yet they are burning out within a week.

Are they maybe a bad batch of bulbs, can't think of anything else since the wattage is lower then the max for the fixture.
 

· Registered
Joined
·
128 Posts
Again I was over helping a friend with some light fixtures. Their light above the sink says it is rated at 120v 75w. The bulbs they are using are a 65w, yet they are burning out within a week.

Are they maybe a bad batch of bulbs, can't think of anything else since the wattage is lower then the max for the fixture.
more of a voltage thing...get 130 volt bulbs they have sttronger filament...you need to check the voltage...but, if i had to guess you have a bad batch of bulbs
 

· Registered
Joined
·
20 Posts
Discussion Starter · #5 ·
I will let them know. The white plastic around where the bulb goes in was a bit discolored as well. Signs of it being rather hot, would a higher voltage bulb with lower wattage help with lowering the heat output from the light.
 

· Registered
Joined
·
1,802 Posts
cheap bulbs

One time my wife brought home a quanity of light bulbs that were on sale - cheap. They did not last long at all - seems I spent the next year or two doing nothing but changing light bulbs until I used them all up. :eek:
 

· Registered
Joined
·
20 Posts
Discussion Starter · #11 ·
If the heat can't escape effectively, lamp life can be reduced substantially. Vibration can also be a problem. Voltage too, of course.

It is definitely getting warm under the glass housing. I guess a lower wattage bulb would help somewhat with that. No vibration though, they live on a quiet dead end road, and ranch style house.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top