DIY Home Improvement Forum banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I'm putting in a new bath tub and will be tiling the walls. Before putting the tub in, I made sure the floor was level. However, when I put the tub in, the tub isn't level. I added mortar mix to level it out. This helps, but there is still a small gap where the face of the tub meets the floor, causing the tub to rock. Any suggestions for getting the tub to be level?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.