[TryingNotToCry]

Hey guys, maybe someone can help me out. I am converting my fluorescent lights to LED and I forgot to label wires before disconnecting. Four fixtures run off of these wires: two fluorescents, a chandelier, and a stove top light and vent combo. I can get power to the chandelier with the two wires you see connected. That was the only wire I was able to find current on with my multimeter. There is only one switch per fixture. Any idea on how I should proceed?

 

[joed]

Are the switches all in the same box? Can you open the switch box and show us the wiring in there.

 

[HandyAndyInNC]

Use an ohm meter to see where the conductors go.

 

[FrodoOne]

Use an ohm meter to see where the conductors go.

With any and all of the Circuit Breakers concerned turned OFF.

 

[TryingNotToCry]

Sorry for the delay on responding, the project was set aside for awhile due to other life events. I mapped out hot wires and continuity. I drew a little diagram. I am still scratching my head.

 

[TryingNotToCry]

B, C, and D are all hot.