DIY Home Improvement Forum banner

Laminate Flooring Questions

2523 Views 3 Replies 4 Participants Last post by  Floorwizard
Hello!

I'm installing our laminate floor for the very first time and would like some help...

I've a bunch of questions (with pictures!), so please bear with me...

The first question is, we're going to laying the laminate over the existing linoleum, simply due to the difficulty it pulling up the old stuff. We've got the underlay, but is there anything else we need to know before going forward?

Second question (first picture!):

http://plofo.shutterfly.com/905

I assume we could just undercut the door frame here to install the floor? The piece to the left is quarter-round and will be removed..

Third question:

http://plofo.shutterfly.com/906

As you can see, the transition here is pretty ugly.. I assume we'd just pull up the gold piece and replace with the new transition piece, placing the carpet UNDER the one side of the piece?

Fourth question:

http://plofo.shutterfly.com/907

Any ideas on how to take these angles? We're going on a 45 degree angle from the gold trim (following the seams in the linoleum) towards the bottom right corner of the picture.

Fifth question:

http://plofo.shutterfly.com/902

http://plofo.shutterfly.com/904

As you can see, this section of floor is pretty beat up. It leads to the sliding door.. The linoleum is curled up and pretty damaged. I think we can probably screw it down to the wood that's there (or glue it) and just apply the laminate over top. The quarter round or a transition piece would be applied to the aluminum frame..

Thanks for the help in advance!!

Justin
See less See more
1 - 1 of 4 Posts
Ericka,

yes, undercut is fine.

yes, the edge goes. but the transition is called an end cap or baby threshold. the carpet butts up to the transition, it does not go under it.
dont make the mistake of using a t-mold.

It requires more cuts, more waste and adds difficulty if your going to install diagonal.
make sure you feel OK with this.

as Bill said...cut the curls in the Vinyl.

By the way...THANK YOU for the pics.
you may not know...but it makes a WORLD of difference for us!

your awesome
See less See more
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top