DIY Home Improvement Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,316 Posts
Discussion Starter · #1 ·
this is the metal fire door on my shed. i used 4 little cans of Smart Strip, which works OK on flat surfaces but not too well in corners. i was wondering if i am ready to reprimer and repaint at this point, i.e. whether the little imperfections are gonna show too bad.

thanks
 

Attachments

·
Too Short? Cut it Again!
Joined
·
9,634 Posts
Looks like you are getting close. You need to get all that stripper off and do a little sanding. You will need to prime before painting.
 

·
Registered
Joined
·
2,316 Posts
Discussion Starter · #3 ·
are you sure this white stuff is the stripper? i thought it might be the primer. if it is the stripper indeed, do you think it's bad if i don't completely scrub/sand it off? cause it is one major grueling task to do... :hammer:
 
1 - 4 of 4 Posts
Top