DIY Home Improvement Forum banner
1 - 9 of 9 Posts

·
dIYHell
Joined
·
229 Posts
Discussion Starter · #1 ·
I need to install to Post bases into a concrete slab. Id like to epoxy threaded rods but wondering is there a way to do this without buying the expensive Epoxy gun to do the Job. I think I saw Simpon had a product in a Single Tube is that correct?
 

·
Old School
Joined
·
3,634 Posts
Most masonry dealers (they sell blocks and lintels) will carry caulking tubes of epoxy that fit a regular caulking gun.
 

·
Registered
Joined
·
14 Posts
Yeah, I just picked some up at one of the big chain stores this past weekend. Fits the large caulk gun, which cost about 7 bucks (1qt maybe??)

Think the epoxy itself was about $11-12 tube; only color available was grey.
 

·
Registered
Joined
·
6,734 Posts
i gotta see this - a single part epoxy ? at an apron/vest store ? masonary OR paint aisle ? haven't seen a single part epoxy yet ! thanks !
 

·
Registered
Joined
·
6,734 Posts
thanks - you saved me a trip :thumbup: about all we can use from those places is 6mil plastic, rolls of perforated hdpe pipe, & marking pencils :laughing: altho we will pick up a small tub of hydraulic cement now & then - that mtl is a sealant w/specific width/height rqmts - its not an adhesive
 

·
Member
Joined
·
185 Posts
1 - 9 of 9 Posts
Top