DIY Home Improvement Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi!
I’m trying to install the intermatic EH 10 in a single pole light switch (hot + neutral)
But i don’t know what goes where


In the photo above i connected the hot wire on the 2nd spot with bridge to the 3rd. But if i touch the 1st spot with the neutral it short circuits and with the 4th nothin happens.

My guess is
1- neutral
2- Line
3- bridge
4- ground (ground it with the green screw on bottom)

thanks!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top