DIY Home Improvement Forum banner

Installing Used Wire Utility Shelving

501 Views 3 Replies 3 Participants Last post by  wpollock
I am going to install some basic "Rubber Made" type wire shelving in my laundry room and kitchen pantry an would like to ask if I can reuse the wall clips the back of the shelf seats into? Same question applies to the end brackets as well.Picture of wall clip attached for clarification.


See less See more
1 - 1 of 4 Posts
As have I, but find the type with the drive pin (vs. screw) tend to be loose the second time around. Also, if the original pilot hole was a little too big, or got enlarged during removal they can be sloppy. Not much ventured if it doesn't work they're a couple of bucks for a bag.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.