Installing Used Wire Utility Shelving

503 Views 3 Replies 3 Participants Last post by wpollock, Feb 14, 2020

wpollock

Discussion Starter · Feb 14, 2020

I am going to install some basic "Rubber Made" type wire shelving in my laundry room and kitchen pantry an would like to ask if I can reuse the wall clips the back of the shelf seats into? Same question applies to the end brackets as well.Picture of wall clip attached for clarification.
Thanks

See less See more

Save

1 - 2 of 4 Posts

wpollock

Discussion Starter · #4 · Feb 14, 2020

I will be installing these as a new installation so will be drilling pilot holes from the get go and not reinstalling in a same location. As you can see in the picture the flare ends are still attached so don't believe they are broken

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.