[wpollock]

I am going to install some basic "Rubber Made" type wire shelving in my laundry room and kitchen pantry an would like to ask if I can reuse the wall clips the back of the shelf seats into? Same question applies to the end brackets as well.Picture of wall clip attached for clarification.
Thanks

 

[Nealtw]

Yes if they have not broke, I take them out to paint and put them back in.

 

[lenaitch]

As have I, but find the type with the drive pin (vs. screw) tend to be loose the second time around. Also, if the original pilot hole was a little too big, or got enlarged during removal they can be sloppy. Not much ventured if it doesn't work they're a couple of bucks for a bag.

 

[wpollock]

I will be installing these as a new installation so will be drilling pilot holes from the get go and not reinstalling in a same location. As you can see in the picture the flare ends are still attached so don't believe they are broken