DIY Home Improvement Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I am installing a T&G pine ceiling for our screened in porch. The question I have is what to do where the boards meet at the hip corners. What should the look be? Do I cut them at an angle and overlap (this will need to be very maticulous to make sure the line going up the ceiling on both sides stays straight), or butt them and use a small half round trim to cover? I also have an attached Gazebo which I will have the same issue with.
Any ideas would be a great help!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.