Personally, I'd go with 2 - 3/8" expansion anchors at the furring strips as my first option, but the Tapcons should work fine as well.............
Installing LCD to cement block
I'll be installing an LCD television for my mother in her basement, and it's getting done on an exterior wall, in which the construction is 1/2 inch drywall backed by furring strips, then cement block. There's maybe a good inch between the drywall and the block. I plan to drill through the drywall, lined up with a furring strip, then into the cement block with a hammer drill and a 3/16 inch cement drill bit then using 1/4 inch x 2-3/4 inch long Tapcon anchors. I also understand that the cement block is hollow with maybe an inch or inch and a half of bite. My question to you guys is, will 2-3/4 inch length anchors be long enough? I plan to use 6 to 8 of them, 4 of which will be lined up with the two furring strips 16 inches apart for more snug of a hold.
The television is an LCD and weighs approximately 60 lbs. I plan to use a rack with the tilting feature, not the pivoting arm. TIA
The television is an LCD and weighs approximately 60 lbs. I plan to use a rack with the tilting feature, not the pivoting arm. TIA
