DIY Home Improvement Forum banner

Installing heating accessory element

604 Views 2 Replies 3 Participants Last post by  Technow
The unit has power. I installed the heating element and connected the 6 pin connector to the control board 031-01264-002. Thermostat wires is connected to red and white. This unit is not connected to a heat pump, will be used for electric heat only. Unit is not operating any suggestions?
1 - 3 of 3 Posts
Have you jumper R-W at control board?

Sent from my iPhone using DIY Forum
whats you wire/breaker size to the airhandler?:(
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top