DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
We are installing a front load steam washer and dryer. Because of the cabinets above them, we have to put a wood panel on each side of the set to support the cabinets above them. Our contractor says we have to have 17" clearance above the W/D. I'm reading that is only if its in a closet, which its not. The room is open, just the W/D and cabinets on the right side of the units. Would the panels make it be enclosed enough to call it a alcove or closet?
 

·
Registered
Joined
·
11,194 Posts
The units come with instructions. Follow them as opposed to the contractors opinions.
Ron
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top