DIY Home Improvement Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
14,665 Posts
I'm very much confused at what you want to know? Did you remove the thermostat wires? Are those the wires you're talking about? Your pictures aren't helpful at all.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #6 ·
Not the thermostat wires I'm going to send better picture ok the spots were wires plug up I need to know what wire goes where red to ? White to ? and so on please I have it wired up but I don't think it is right because the
furnace is working but the outside unit is not coming on .
Passive circuit component Circuit component Hardware programmer Finger Computer hardware
Musical instrument Audio equipment Font Gadget Musical instrument accessory
Circuit component Font Gas Electronic component Audio equipment
Font Gas Machine Electronic device Automotive exterior
Temperature Font Gas Electronic device Metal
Nail Font Plastic Electric blue Fashion accessory
Product Cosmetics Audio equipment Gas Electronic device
Passive circuit component Circuit component Hardware programmer Finger Computer hardware
Circuit component Font Hardware programmer Computer hardware Electronic component
Musical instrument Audio equipment Font Gadget Musical instrument accessory
Musical instrument Audio equipment Font Gadget Musical instrument accessory
Product Cosmetics Audio equipment Gas Electronic device
Circuit component Font Hardware programmer Computer hardware Electronic component

Circuit component Font Hardware programmer Computer hardware Electronic component

Product Cosmetics Audio equipment Gas Electronic device

Temperature Font Gas Electronic device Metal

Nail Font Plastic Electric blue Fashion accessory

Font Gas Machine Electronic device Automotive exterior

Circuit component Font Gas Electronic component Audio equipment

Musical instrument Audio equipment Font Gadget Musical instrument accessory
 

·
Registered
Joined
·
8,169 Posts
The issue you described is a possible low voltage issue.
Is the condenser getting a call to run? Test with your meter.
Why did you remove the entire control board? Why is there a large burn mark on the board?
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #8 ·
Lightning strike my house and burned the board up put a new one on it but picture I took why it was in there did not turn out good know I'm stuck I don't know if I have it wired up right
 

·
Registered
Joined
·
8,169 Posts
You’ll have to follow the wiring schematic and double check each wire.
With the limited information we can’t tell you exactly where each individual wire goes.
It sounds like you need to do some diagnosing with your meter to see why the condensers not running.
 
1 - 11 of 11 Posts
Top