DIY Home Improvement Forum banner
1 - 1 of 1 Posts

· Registered
10 Posts
Discussion Starter · #1 ·
I'm remodeling my laundry room, and the existing plumbing situation in there is...bad.

I need to replace the washer hookups, and add proper hookups for a wash sink. I'd like to set it up like this

But the space is too tight to get the existing T off. I've considered starting over and replacing all my plumbing with pex, but I've got a very short crawl space with the plumbing buried behind insulation...a project for another time.

I could maybe leave the old T in place, and cap off the existing faucet spot - I'd like to place a T a few inches higher to clear the drain pipe.

Thoughts and advice?

Thank you!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.