DIY Home Improvement Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
I'm building a bar and I have the front and sides on but I want to add some trim moldings(like half round or similar) in a rectangular shape on the sides of the the bar. I tried to do this a few ways and things were not always lining up. What is the best way to tackle this so they are both align. Some type of jig or alignment tools. Thank you very much!!!!!!!!!!
 

·
Registered
Joined
·
37,177 Posts
The jig is called a tape measure.
Just find center and take all your measurements from there.
 
1 - 4 of 4 Posts
Top