DIY Home Improvement Forum banner

Honeywell Vision Pro 8000 system wait

831 Views 4 Replies 2 Participants Last post by  php
I have our heat pump installed in 2018 with gas furnace backup heat.
The thermostat status is now wait. After five minutes it will be back on and then went back to wait status after a few minutes. What would cause this behavior?

If there is already a thread for this issue, please share.

1 - 3 of 5 Posts
I got it working. The problem, I think, is a critter chewed up the wires outside and a couple wires had ripped insulation. It was working fine until it started to rain. I think the wires got wet and short circuited. I reinsulated the wires and wrapped all together with an electrical tape once dry. It works now. Thanks.
Well it is not yet working. This morning the behavior repeats. The same pattern. The tstat is reading outside temperature in 5, 6 deg range, between 31 and 37 for example. The sun is not out yet. I checked all the wire and they all are connected correctly.
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.