Honeywell Vision Pro 8000 system wait

832 Views 4 Replies 2 Participants Last post by php, Jan 14, 2020

php

Discussion Starter · Jan 12, 2020

I have our heat pump installed in 2018 with gas furnace backup heat.
The thermostat status is now wait. After five minutes it will be back on and then went back to wait status after a few minutes. What would cause this behavior?

If there is already a thread for this issue, please share.

Thanks.

Save

1 - 2 of 5 Posts

roughneck

· #2 · Jan 12, 2020

Sounds like something is interrupting the power supply and sending the thermostat back into it’s time delay mode.
Or it’s right around it’s switchover temp and keeps bouncing between modes. Sun on the outdoor sensor can cause this.

Save

roughneck

· #4 · Jan 14, 2020

Glad you got it working.
Conduit would help prevent further issues like that.

Save

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month