DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am trying to install a Dayton 4m205J motor(matched up by graingers) it is 1/4hp 208/230V.

It has 4 wires plus a green ground.
they are: Black, Brown, Brown/white, Purple


My old motor was Franklin Electric 1/8hp 208/230 V 3 wire: Brown, Red, Black.

I also have a new Start fan capacitor. (one side of the capacitor has a black wire hooked to it) This was also the side where the black wire on my old motor hooked into. The brown was on the opposite side. The red wire hooked into the contactor(I think thats what its called) with a larger guage red wire.


How do I wire this new motor? Thank you!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top