DIY Home Improvement Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
286 Posts
Discussion Starter · #1 ·
Have a 97 Chevy pick up k1500 brakes were weak so replace drum brakes in the back, wheel cylinder, and all hardware, also replaced master cylinder... After bleeding brakes, nothing coming out, even when I took brake lines off to do the master cylinder, nothing really came out??? Help anyone!!!!!
 

·
Registered
Joined
·
1,225 Posts
I also do not get it. After bleeding brakes nothing come out. Out of where? So you managed to bleed the brakes and it WAS coming out? Then stopped?
Why do I have that suspicion that you do not have brake booster push rod properly connected?
Or, simply have bad master? Happens.
 

·
Registered
Joined
·
258 Posts
there is a button on the proportioning valve that needs a reset before bleeding.
Look it up as I can't tell you exactly what to do as it has been years since I did brakes. Depress it or pull it while you bleed. ??

Pressure or vacuum bleeding works best on this model.

Good luck!

RR :smile::smile:
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top