DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I had installed a new Heil furnace in 1993, model 867.769426. Gas Valve VR8204M 1075, Ignitor H01007457HW.
About 5 years ago I had the pilot cleaned. Now, it's not lighting up again. I cleaned it and it works fine. I have the flame on the pilot covering half.
When looking at the flame after it is running, the top prongs on the ignitor are glowing red after a couple of minutes. Is this normal?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top