generator transfer switch

2174 Views 8 Replies 4 Participants Last post by Jim Port, Jun 30, 2011

chuck172

Discussion Starter · Jun 30, 2011

I'm installing a generator 6 circut manual transfer switch. Looks like I need to either splice the circuts in the load center (circut breaker box) and bring the wires out to the transfer switch, or I can pull the wires out of the load center and add junction boxes and then route the circuts to the new generator transfer switch.
I have the room in the load center. I'd prefer this method. Is it up to code?

Save

1 - 1 of 9 Posts

Jim Port

· #9 · Jun 30, 2011

Typically the NM clamps are for 2 flat cables like 14-2, but only one 3 wire like 14-3. Check the packaging.

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.