DIY Home Improvement Forum banner

generator transfer switch

2177 Views 8 Replies 4 Participants Last post by  Jim Port
I'm installing a generator 6 circut manual transfer switch. Looks like I need to either splice the circuts in the load center (circut breaker box) and bring the wires out to the transfer switch, or I can pull the wires out of the load center and add junction boxes and then route the circuts to the new generator transfer switch.
I have the room in the load center. I'd prefer this method. Is it up to code?
1 - 4 of 9 Posts
Anyone?

Any answers? I'd like to get started on this.
Can I fit all 6 circuit splices in one junction box?
What size box should I get?
Can two romex 12/3 wires go through the same knockout and both share the same clamp?
1 - 4 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top