[jpc]

hello, and thanks in advance, ive gotten so much help on this site in the last six months.Right now im 3/4 of the way done with my first hardwood install in my sons room, so far am happy with the results, a few places have small gaps and after looking on here most of the gap repair threads where with older installs where the gaps came from wood movement, my couple spots were where i just couldnt get it to tighten all the way up, does that mean im in trouble later? IVe also dinged up some of it up while doing the install, is sanding and some type of clear coat the way to go?In those gaps could i take the the extra peices and run them down my TS cutting veneer thin strips maybe 1/16 or so and fit them in the gaps and maybe finish over them, So of this info might help, its 3/4 thick 2and a half inch thick oak from the big box ,Any advice or ideas id appreciate, thanks again

 

[jpc]

thank you for taking the time to respond, and i think thats the route im going to try