DIY Home Improvement Forum banner

Furnace Won't Fire - Suggestions?

708 Views 7 Replies 4 Participants Last post by  rootboy
I have an American Standard 90 furnace. I just moved in a few weeks ago and we fired it up with no problem. About a week ago, it stopped putting out hot air and would only blow cold. I quickly learned that it wasn't firing and thus.....cold air. I pulled the filter and noticed it was completely plugged. I have tried replacing the pressure sensor switch with no luck, tried resetting the main limit switch and the flame rollout switch. I am assuming the furnace overheated, but not sure how to get it to come back to life. BTW, the heat inducer fan powers up until the furnace tries to fire, then it shuts down. I never get a pilot or any flame. Thanks
1 - 1 of 8 Posts
Do you have continuity thru all of them. Te wiring legend on the furnace should show where they all are in the wiring diagram
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.