DIY Home Improvement Forum banner

furnace blower fan

1516 Views 4 Replies 2 Participants Last post by  590610jt
If I run my furnace in heat cycle or ac cycle, the fan may run fine to shut off after cycle but sometimes stays on. If I tap the side of the furnace it shuts off. Could this just be the blower motor relay or is it the sequencer. this is a bryant electric furnace.
1 - 2 of 5 Posts
Sequencer only works with the heat. If it stays on with AC then it is the fan relay/blower motor relay.
Not the best advice. There should be more than 1 sequencer and if you disturb them and yank wires off they sometimes start to stick and you then created a problem. Sequencers don't work with AC.
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.