DIY Home Improvement Forum banner

French door mortice locks

3K views 6 replies 3 participants last post by  ScottR 
#1 ·
I bought a set of French doors at a rebuilder supply without the hardware thinking I could to the home supply stores and get what I needed. Now I cannot find it.

The door are morticed, inswing left hand and I am trying to find out who made them originally so I can buy the right kit. The glass has what looks like the milgard logo and a date of 1975. Milgard says they did not make French doors in 75, now I am at a loss. They are framed in and I cannot secure them.
 
#7 ·
you could redrill the door for a cylindrical entry lock and mount it in a Kwikset 215 modernization kit. Link below. That would close and cover all of the holes.
Ooh, good call. I didn't even know that those existed. :thumbup:

BTW - I'd get as good a fit as possible with the wood block, fill in around the edge with bondo (or similar), and sand like crazy. Then use hardware with large escutcheons to cover any old holes or whatnot on the sides, if needed.

But the retrofit kit seems muuch easier.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top