DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I'm getting the house prepped for vinyl siding and have run into a little problem with regard to my wall profile. Attached is a drawing of my wall profile. Does anyone have any suggestions as to how I would go about transitioning from the bottom course of siding to the 2" insulation. All the Z flashing around here is only 1" stuff or less.

Any suggestions appreciated
 

Attachments

·
Registered
Joined
·
430 Posts
when I needed some pan flashing for patio doors (couldn't find anything in the box stores - and never used a brake) I went to a siding contractor in my area and they bent some stock for me - actually didn't cost much. I gave them a simple sketch with dimensions and they did it up right away.
 
1 - 2 of 2 Posts
Top