DIY Home Improvement Forum banner

Faced or unfaced

1462 Views 3 Replies 3 Participants Last post by  AllanJ
Confused a bit here, I put 2" XPS foam on some parts of my basement walls and 1" foam board on other parts. Now I'm confused if I should go with a faced or unfaced insulation to fill the framing in?

My issue is, the foam board is 6" short of the floor. I attached it this way so my dry cove and board butt flat up to one another and any water coming in from the wall will drain directly into my french drain.

I attached a picture showing the gray drainage cove.


See less See more
1 - 1 of 4 Posts
You will need to provide a bit more information.

Where is the home?
What does the exterior wall consist of?
Wall construction type?
Is there a sump pit and ejection pump?
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.