DIY Home Improvement Forum banner
1 - 1 of 1 Posts

· Registered
569 Posts
Discussion Starter · #1 ·
So last weekend I installed my neighbors Evergreen motor into her Lennox gas pack. I also installed an Aprilaire 600 humidifier in her laundry room and a White Rodgers touch screen stat with humidity control. I set up the stat to engage the fan whenever humidity is needed and because it's such a slow speed, she doesnt really even know when the fan is running, except for a heat call.
I'm really impressed with this motor and it was a snap to install, however the Lennox unit required removing the top and I had to extend the wiring harness to reach the control compartment.
I've also ordered one of these motors for my unit but wont install it until I decide if I'm going to change out the unit, if I do, I'll install it in the new unit.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.