DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5,203 Posts
I recently used some pointed (think arrow tip) carbide bits to drill 3/16. I started with a smaller one to score the surface. Slow speed using an 18v drill.

Back when I occasionally had to drill in walls I used some diamond bits shaped the same.

Always used slow speed and no hammer.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top