Drill through or Tapping steel plates for countertop

2270 Views 1 Reply 2 Participants Last post by John_F, Jun 25, 2009

rocketdoctor

Discussion Starter · Jun 25, 2009

I need to attach a post to a 1/2 steel plate for a countertop. to do this I can either drill through and put the screws in from above or I can drill tap for screws, Ideally I would like to drill and tap but how hard would this be to do with handheld drills and a tap set?

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.