DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,670 Posts
Look down into the drain pipe. There may be a rubber collar inside it to prevent the hose from coming out during the discharge cycle of the washer.
 

·
Registered
Joined
·
1,670 Posts
Most likely just a slip-fit. It may be difficult (but possible) to remove since the soaps from the washer may have "sealed" it. If you can, pour some really hot water into the pipe to soften the seal. Then twist and pull.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top