DIY Home Improvement Forum banner

drain clogged

1682 Views 2 Replies 2 Participants Last post by  larbec
2
I have an American Standard 5 Ton gas furnace installed in 2005. In 2007 I replaced the plumbing under the unit because the drain pipes were in bad condition. Last week we had water all over a hardwood floor and I noticed the unit was clogged again. I took the tops off the 3/4" pvc drain line and used my wet vac to suck the water, used drano and it appears to be fine now.

How do I take the cover off to look at the drain pan and coils? It is inside n my closet. So much room LOL

Model TXC060C5HPCO

Attachments

See less See more
1 - 3 of 3 Posts
Why did you use draino near a GAS furnace... You could have blew yourself up.
I used it under the unit where the drain plug is in the floor NOT by the unit
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top