Door trim in tight areas???

2173 Views 7 Replies 5 Participants Last post by ponch37300, Apr 21, 2009

gone_fishing

Discussion Starter · Apr 20, 2009

I am finishing a remodeling project. The one door has vent soffits above both sides and is tight to one wall. Therefore, on one side I can fit traditional trim on both sides but not the top. On the other I only have about 1 1/2 on the right, 3-4" on the left and 1 1/2 on top.

How do you suggest trimming this out?

Thanks!
Kevin

Save

1 - 1 of 8 Posts

Gary in WA

· #2 · Apr 20, 2009

Center so one side casings are same width. If door is not near another, cut jambs and door down to get head the same as casing width. You won't see both heads at once. Be safe, GBR

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.