DIY Home Improvement Forum banner

DIY Spray foam

1791 Views 7 Replies 6 Participants Last post by  BigJim
I'm considering spray foaming the underside of the roof of my 24x28 garage/workshop.
It's a trussed roof and the floor is plywooded and used for storage otherwise, I would batt insulate it.
Have any of you spray foamed something like this?
Pros? Cons?
1 - 8 of 8 Posts
One job I would hire out.
Ever seen it done by a pro before?
There going to have all the proper equipment and get this done in less then a day.
It's one nasty messy job.
Hey TC, where ya been?
Not sure. Usually when this is done. They install the ventilation shoots in-between the rafters before foaming. You said trusses. So i'm not sure.
Hey TC, where ya been?
Hey Jim,
I had some health issues and needed to lay low for a bit.
I've been over in the WWT turning section.
I got a new lathe but the old one's still being used with the banjo you gave me.
Good to see ya !!!!
Tom
Hey Jim,
I had some health issues and needed to lay low for a bit.
I've been over in the WWT turning section.
I got a new lathe but the old one's still being used with the banjo you gave me.
Good to see ya !!!!
Tom
I see you on WWT all the time, I hope you are doing better now days buddy.
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top