DIY Home Improvement Forum banner

Diagram for small can lights

1773 Views 6 Replies 4 Participants Last post by  mackdoyle
I do not know a lot about electrical.
I ran Romex from a switch to can1 then to can2 then to can3 then to can4 and the wiring terminated at the 4th can. Now the 4th can light keep burning out.

Was I supposed to complete the loop or something? I am not sure what is occurring. any help would be appreciated.
1 - 1 of 7 Posts
If it goes on and off with the other lights and is normal brightness then you wired it proper. Something else is wrong.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.