Diagram for small can lights

1773 Views 6 Replies 4 Participants Last post by mackdoyle, May 23, 2011

mackdoyle

Discussion Starter · May 22, 2011

I do not know a lot about electrical.
I ran Romex from a switch to can1 then to can2 then to can3 then to can4 and the wiring terminated at the 4th can. Now the 4th can light keep burning out.

Was I supposed to complete the loop or something? I am not sure what is occurring. any help would be appreciated.

Save

1 - 1 of 7 Posts

NJMarine

· #4 · May 22, 2011

What size bulb are you using?
What type trim on the light?
Bulbs can burn out for some diffenet reasons.
Inside of fixture get to hot make sure bulb being used is correct for fixture and trim.
If you can get them try bulbs rated for 130 volts

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.